Anchor Installation Instructions

Installing split drive anchors can be completed in four simple, standard steps. These anchors are made for use in solid base material such as concrete. When using split anchors, make certain that it is for dead loads only. Split Drive Anchors can come with either a flat counter sunk head or a round head depending on the type of project.

1. Drill hole in concrete with carbide tipped bit meeting ANSI standards. Hole should be drilled minimum embedment or deeper, plus 1/4”

2. Clean dust out of hole.

3. Insert anchor through fixture and into hole.

4. Hammer anchor into hole flush with the top of fixture.

---

Back to top | Purchase Split Drive Anchors | Other Concrete Fasteners and Anchors